Removing Receivers Or Pumps - MAGUIRE Weigh Scale Blender 4088 Installation Operation & Maintenance

Removing Receivers from the configuration
If a receiver needs to be removed from the configuration, it can be removed using this procedure.
On the HOME
screen PRESS:
PRESS:
This enters the Setup screen. This screen contains several setup specific options.
PRESS:
The screen will contain any previously assigned devices (Pumps or Receivers).
A device must be turned off or communication must be disconnected to remove the
device. When a device is turned off or communication to the device is disconnected, the loader
or pump icon will show a red X over it. The red X enables the option for the device to be
removed by pressing the device.
PRESS:
A prompt to remove the receiver will be shown.
PRESS:
PRESS:
PRESS:
Pressing the SETUP button prompts for a
password.
Enter the password (default password is 22222)
22222
Press
Press the large Receiver button.
To remove the receiver.
To return to the Setup screen. When you return to
the Setup screen, the Receivers button will show
the Setup symbol indicating that you are still in the
Receiver Assignment mode.
To Exit the Assignment Mode. Setup icon will
disappear indicating you are out of the assignment
mode.
To exit the Setup screen.
to confirm password.
139