Flexbus Pump Assignment - MAGUIRE Weigh Scale Blender 4088 Installation Operation & Maintenance

Pump Assignment -
Flexbus Lite (part of the Maguire 4088 TS Weigh Scale Blender) controls a single pump. The
Flexbus System can control of to 5 pumps. If you have two or more pumps (Flexbus only), turn
OFF all pumps prior to running Setup in the Flexbus controller, otherwise: To assign Pumps,
follow these instructions:
On the
HOME
screen,
PRESS:
PRESS:
This enters the Setup screen. This screen contains several setup specific options.
To setup
Pumps:
PRESS:
This enters the PUMP assignment screen. This gray screen contains any previously assigned
pumps. For first time setup, this screen is probably blank and no pumps have been assigned.
At this time, turn on your Flexbus Lite Pump to assign.
With a single pump, that pump will
appear on the screen and be labeled
with the number 1.
PRESS:
PRESS:
Pumps must be assigned before Receivers.
Pressing the SETUP button prompts for a password.
Enter the password (default password is 22222)
22222
Press
Press the large Pumps button on the far left of the
screen.
To return to the Setup screen. When you return to the
Setup screen, the Pump button will show the Setup
symbol
still in the Pump Assignment mode.
To Exit the Pump Assignment Mode. Setup icon
overlaying the button will disappear indicating you are
out of Pump assignment mode.
to confirm password.
on the Pump button indicating that you are
131