Change Passwords - MAGUIRE Weigh Scale Blender 4088 Installation Operation & Maintenance

Changing Passwords
Access to the controller is limited by one or two passwords. Access to Setup information is restricted by
an Admin Password (default password is: 22222). If Operator Access is enabled (see above), access to
commonly used functions are further restricted with the Operator Password. If security is important and
restricted access is desired, it is important to change the passwords.
Press
Press System Configuration
Press Preferences
Press

Change Passwords

Enter the new password
Press
52
Display will prompt for a password.
(admin default: 22222)
Display will show the System Configuration categories.
Display will show System Preferences categories.
Display will show three options, Change Admin Password,
Change Operator Password and Enable Password Mask.
Select the password you wish to change.
Check Enable Password Mask to hide the password and show
the asterisk instead of the password numbers when entering a
password.
then enter the password again to confirm.
To save the changes or press the
red X to cancel and exit.
Then press: