MAGUIRE Weigh Scale Blender 4088 Installation Operation & Maintenance page 44

Restoring Parameters from Backup
If software related problems develop later or a firmware update is applied to the controller, this
routine will restore the last saved configuration of the blender stored within User Backup Settings.
Press
Press System Configuration
Press
Press User Settings
Press Restore User Settings
Press
44
Display will prompt for a password. (default: 22222)
Display will show the System Configuration categories.
Resets Display will show the categories of System resets:
User Settings, Factory Access, Restore Factory Defaults,
Firmware Update.
Display will show Restore User Settings / Save User Settings.
Display will prompt for confirmation to Restore user settings.
To restore the user settings including
parameters or press the red X to cancel and exit.
Then press: