Fault - Angelo Po FX61E3 Use And Installation Manual

TROUBLESHOOTING
The appliance has been tested before being put into service.
The information provided below is intended to assist in the identification and correction
of any anomalies and malfunctions which might occur during use.
The user can solve some of these problems himself, but for others specific technical
knowledge or skill is required, and so they must only be carried out by qualified staff
with recognised experience acquired in the specific sector of operation.
Important
For all requirements contact the agents or the headquarters of Angelo Po which
can be found in the contacts section of the website http://www.angelopo.com.

Fault

The appliance
switch on
Cooking cycle does not start
or stops suddenly
The cleaning cycle does not
start or stops suddenly
IT
GB
DE
FR
TABLE OF ALARM INDICATIONS
ES
If the problem or fault noticed is not amongst those
listed in the table, consult the "Key to Alarms" table
provided below.
The information provided below s intended to identify
the alarm signals which appear on the display (A).
Important
Press button (D) to reset the alarm.
English
FAULT
Remedy
Fuse "blown"
Safety or
does not (safety thermostat or overload
cutout) tripped
Electronic circuit board dam-
aged
Control board electronic circuit
board damaged
Alarm triggered
Control board electronic circuit
board damaged
Alarm triggered
Remedy
Replace the fuse (see page 82)
protection device
Press device reset button
Contact the after-sales service
Contact the after-sales service
Consult the "Key to Alarms" table
Contact the after-sales service
Consult the "Key to Alarms" table
A
D
- 68 -
6
IDM-39617700700.tif
Use and installation manual