Fault - Angelo Po FX 82 E3T Use And Installation Manual

TROUBLESHOOTING
The appliance has been tested before being put into service.
The information provided below is intended to assist in the identification and correction
of any anomalies and malfunctions which might occur during use.
The user can solve some of these problems himself, but for others specific technical
knowledge or skill is required, and so they must only be carried out by qualified staff
with recognised experience acquired in the specific sector of operation.

Fault

The appliance
switch on
Cooking cycle does not start
or stops suddenly
The cleaning cycle does not
start or stops suddenly
TABLE OF ALARM INDICATIONS
If the problem or fault noticed is not amongst those
listed in the table, consult the "Key to Alar ms" table
provided below.
IT
The information provided below s intended to identify
the alarm signals which appear on the display (A).
GB
Important
Press button (D) to reset the alarm.
DE
FR
ES
Alarm Fault
No water in chamber, or water
H2O
pressure too low
No water at drain, or water pres-
H2O.
sure too low
English
FAULT
Remedy
Fuse "blown"
Safety or
does not (safety thermostat or overload
cutout) tripped
Electronic circuit board dam-
aged
Control board electronic circuit
board damaged
Alarm triggered
Control board electronic circuit
board damaged
Alarm triggered
Remedy
Check that mains water is present
or adjust the pressure (see page
59); if the problem persists inform
the after-sales service
Check that mains water is present
or adjust the pressure (see page
59); if the problem persists inform
the after-sales service
Remedy
Replace the fuse (see page 60)
protection device
Press device reset button
Contact the after-sales service
Contact the after-sales service
Consult the "Key to Alarms" table
Contact the after-sales service
Consult the "Key to Alarms" table
A
D
- 50 -
IDM-39617700700.tif
Notes
Convection cooking cycles can
still be carried out
Convection and steam cooking
cycles can still be carried out
Use and installation manual
6