Fault - Angelo Po FX 82 E2T Use And Installation Manual

TROUBLESHOOTING
The appliance has been tested before being put into service.
The information provided below is intended to assist in the identification and correction
of any anomalies and malfunctions which might occur during use.
The user can solve some of these problems himself, but for others specific technical
knowledge or skill is required, and so they must only be carried out by qualified staff
with recognised experience acquired in the specific sector of operation.

Fault

The appliance does not
switch on
Cooking cycle does not start
or stops suddenly
TABLE OF ALARM INDICATIONS
If the problem or fault noticed is not amongst those
listed in the table, consult the "Key to Alarms" table
provided below.
The information provided below s intended to identify
the alarm signals which appear on the display (7).
Important
Press button (12) to reset the alarm and the cook-
ing cycle restarts automatically; if this is not the
case, press the start key (16).
English
FAULT
Cause
Fuse "blown"
Electronic circuit board damaged
Control board electronic circuit board
damaged
Alarm triggered
Safety or protection device (safety
thermostat or overload cutout)
tripped
Fault
Cause
- 19 -
Remedy
Replace the fuse (see page 29)
Contact the after-sales service
Contact the after-sales service
Consult the "Key to Alarms" table
Consult the "Key to Alarms" table +
Press device reset button
7
12
16
Use and installation manual
6
IT
GB
DE
FR
ES
IDM-39619500100.tif