Fault - Angelo Po 1G1FA0G Use And Installation Manual

The appliance has been tested before being put
into service.
The information provided below is intended to as-
sist in the identification and correction of any anom-
alies and malfunctions which might occur during
use.
The user can solve some of these problems him-
self, but for others specific technical knowledge or
skill is required, and so they must only be carried
Faults
Smell of gas.
The pilot light does not ignite.
The pilot light goes out.
IT IT
The flame is yellow.
GB GB
DE DE
Burner control knob is stiff.
FR FR
ES
ES
English
TROUBLESHOOTING
Occasional leak because flame
The spark ignition devices are not
Air in pipelines due to long period
The thermocouple has not
Burner dirty, heat exchange pipes
clogged, condensation drips.
Gas control valve malfunction.

FAULT

out by qualified staff with recognised experience ac-
quired in the specific sector of operation.
Important
For all requirements contact the agents or
the headquarters of Angelo Po which can
be found in the contacts section of the web-
site http://www.angelopo.com.
Causes
has gone out.
working.
out of use.
warmed up enough.
- 14 -
Remedies
Turn off the gas supply tap and
ventilate the room.
Check that the ignition devices
are in good working order
Light by hand with a naked light.
Important
Contact the after-sales
service.
Make more attempts
to light the flame.
Make more attempts
to light the flame.
Important
Contact the after-sales
service.
Important
Contact the after-sales
service.
6