Replacing Parts - Angelo Po FX61E3 Use And Installation Manual

3 – Unscrew the ring nut (C).
4 – Use the screw (D) (cleaning system water) to bring the pressure reading on the
pressure gauge (E) to 1,5 bar. €
If the water pressure is too low, install a device to increase the pressure.
5 – Retighten the ring nut (C).
6 – Unscrew the ring nut (F).
7 – Turn the cooking chamber water intake screw (G) to bring the pressure reading on
the pressure gauge (H) to 1 bar.
If the water pressure is too low, install a device to increase the pressure.
8 – Retighten the ring nut (F).
9 – Replace the panel (A) and screw the screws back into place.
10 – Turn the water supply tap (B) back off when the operation is complete.
H
G
F
C
INSTRUCTIONS AND WARNINGS FOR REPLACING PARTS
Important
Before carrying out any replacement procedure, activate all the safety devices
provided and decide whether staff at work and those in the vicinity should be
informed. In particular, turn off the water supply tap, cut off the electricity sup-
ply using the master switch and prevent access to all devices that might cause
unexpected health and safety hazards if turned on.
If worn parts have to be replaced, use original spare parts only.
The manufacturer declines all responsibly for injury or damage to components
due to the use of non original parts, or extraordinary work on the appliance
which may modify the safety requirements without the manufacturer's authori-
sation.
When ordering components, follow the instructions provided in the parts cata-
logue.
Caution - warning
Replacement operations must be carried out by authorised, qualified staff, in
accordance with the relevant legal requirements.
English
E
D

REPLACING PARTS

- 81 -
A
B
9
Use and installation manual
IT
GB
DE
FR
ES