Banner AMG Instruction Manual page 7

Asset Monitoring Gateway With SNAP ID Instruction Manual
The system is scanning for the sensors
Sensor Scan/ID Assignment screen with the sensors list populated
The Gateway scans for connected sensors for 20 seconds, as indicated by the red Scanning.... message displayed at
the bottom of the screen. Previously undetected devices appear in the table as ID 1 in the second column. The model
name and sensor type should match the attached sensor/converter. When initially commissioning devices, it is impor­
tant to connect only one new sensor/converter at a time. The gateway scans for new devices based on the default
SID #1 so it is also important to change all identified devices' SID # when you will be adding more than one device.
To change the detected devices' SID #, highlight the sensor needing to be changed by touching the row in which it ap­
5.
pears and select Change ID. Touch Yes to confirm.
The Enter New ID field automatically increments to the closest available SID #. (This field is also manually config­
urable.) After a SID # has changed, the sensor table repopulates and displays the new SID # associated with the
learned device. All previously learned sensors continue to appear in the table unless they are deleted from the system
using this screen.
July 17, 2023
© Banner Engineering Corp.
7