Commission And Assign Connected Sensors Or Converters - Banner AMG Instruction Manual

Asset Monitoring Gateway With SNAP ID Instruction Manual
Change the location name by tapping the menu entry Enter Location and entering a valid location. Select the Utilities menu to
bring up the main configuration and gateway information window.

Commission and Assign Connected Sensors or Converters

After the AMG has initialized (about one minute), touch the Utilities icon in the lower right corner of the main page to
1.
go to the main configuration/device information menu.
2. In the Sensor Utilities column, touch Sensor Scan/ID Assign.
The Sensor table will initially be unpopulated.
3. Connect any supported Banner Modbus sensor or S15 converter using a splitter cable or hub with power connected
to the homerun cable and a branch connected to the Gateway M12 connector on the bottom right of the enclosure.
See the Asset Monitoring Gateway with SNAP ID Brochure, p/n b_51583459 for lists of supported S15 converters,
Modbus sensors, and accessories.
Select Scan IDs and touch YES when prompted to confirm.
4.
6
Utilities screen
© Banner Engineering Corp.
July 17, 2023