Chapter 5 Product Support; Specifications For The Asset Monitoring Gateway With Snap Id; Fcc Part 15 Class A For Intentional Radiators; Industry Canada Statement For Intentional Radiators - Banner AMG Instruction Manual

Asset Monitoring Gateway With SNAP ID Instruction Manual
Chapter Contents

Specifications for the Asset Monitoring Gateway with SNAP ID ....................................................................................................................... 23

FCC Part 15 Class A for Intentional Radiators .................................................................................................................................................. 23

Industry Canada Statement for Intentional Radiators ...................................................................................................................................... 23
Banner Engineering Corp Limited Warranty ..................................................................................................................................................... 23
Chapter 5
Specifications for the Asset Monitoring Gateway with SNAP ID
Supply Voltage
24 V DC (±10%) (use only with a Class 2 (UL) power supply
or a Limited Power Source (LPS) (CE) power supply)
Power Consumption
9 W average; 30 W maximum
Mounting
A mounting system that provides for various mounting options
has been provided with this enclosure.
To connect the mounting brackets, turn the enclosure such
that the backside is visible. Place the mounting brackets over
the bosses either horizontally, diagonally, or vertically, and fas­
ten them with the ¼"­20 x 0.25" SS, countersunk Philips drive
screws provided (torque limit = 30 in. lbs.). The enclosure can
be mounted vertically (on a wall) or horizontally (tabletop)
Enclosure Construction
ABS polycarbonate NON-UV Stabilized. Not for use outdoors.
FCC Part 15 Class A for Intentional Radiators
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Op­
eration of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to
correct the interference at his own expense.
Industry Canada Statement for Intentional Radiators
This device contains licence­exempt transmitters(s)/receiver(s) that comply with Innovation, Science and Economic Develop­
ment Canada's licence­exempt RSS(s). Operation is subject to the following two conditions:
1. This device may not cause interference.
This device must accept any interference, including interference that may cause undesired operation of the device.
2.
Cet appareil contient des émetteurs/récepteurs exemptés de licence conformes à la norme Innovation, Sciences, et
Développement économique Canada. L'exploitation est autorisée aux deux conditions suivantes:
1. L'appareil ne doit pas produire de brouillage.
L'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en
2.
compromettre le fonctionnement.
Banner Engineering Corp Limited Warranty
Banner Engineering Corp. warrants its products to be free from defects in material and workmanship for one year following
the date of shipment. Banner Engineering Corp. will repair or replace, free of charge, any product of its manufacture which, at
July 17, 2023
Product Support
© Banner Engineering Corp.
Operating Conditions
–10 °C to +60 °C (+14 °F to +140 °F )
90% maximum relative humidity (non-condensing)
Environmental Rating
IP65
Certifications
Banner Engineering BV
Park Lane, Culliganlaan 2F bus 3
1831 Diegem, BELGIUM
23