Step 3: Brightness Control; Step 4: Output Settings - NovaStar LVP6082 User Manual

screen, the software NovaLCT-Mars is required to be connected to configure the screen.
c) During Data Flow setting, turn the knob to see the results of different types of data flow
on the screen in real time. If satisfied with the current data flow, you must press the knob
to save the setting. Press return key to exit from current operation.
d) During Data Flow setting, make sure that the data flow of each port is connected along
the same direction.
e) During Data Flow setting, make sure that the start position of Port 1 is the start position
of whole data flow connection.

6.5 Step 3: Brightness Control

Return to main menu interface. Press the knob and select the corresponding value. At this
time, the knob can be turned to adjust brightness value.

6.6 Step 4: Output Settings

Output settings can be divided into three cases:
 I: Point-to-point display, namely, scaling disabled. Size of output image is the same as
input image and the output is based on original proportion.
Horizontal and vertical offset of image are set as required and operation steps
shown in the figure below.
www.novastar.tech
NovaPro HD User's Manual
-12-
are