Appendix 7.14 Fcua-R211 Cable Manufacturing Drawing - Mitsubishi Electric MELDAS C6 Maintenance Manual

APPENDIX 7 CABLE MANUFACTURING DRAWINGS

Appendix 7.14 FCUA-R211 Cable Manufacturing Drawing

Appendix 7.14 FCUA-R211 Cable Manufacturing Drawing
Application:
Control unit – remote I/O unit connection
Remote I/O unit – remote I/O unit connection
Remote I/O unit – communication terminal connection
Assembly drawing
1 2
3
Control unit side
5
Connection diagram
TXRX
TXRX*
LG
FG
Note (5)
Manufacturing precautions
(1) The wire material shall be a shielded 3-pair stranded pair cable equivalent to AWG20 (0.5mm
(2) The parts used shall be Mitsubishi recommended parts. Equivalent parts may be used providing
they are compatible with the specifications.
(3) Attach the nameplate (with protective cover stamped with the cable name) in the position
designated in the assembly drawing.
(4) Install each crimp terminal side after stamping the name of each signal on the mark tube.
(5) Protect both ends of the wire material with insulation bushing.
(6) Use AWG18 (0.75mm
(7) Ground the crimp terminal connected to the shield to the control unit or communication terminal
frame ground.
Note that there may be cases where only one end is connected, both ends are connected, or
neither end is connected to improve the noise resistance,.
1 2
R211
R211
Note (3)
4
1
2
3
2
) or equivalent for the shield treatment wire material.
I - 99
Get other manuals https://www.bkmanuals.com
Option (Compatible connector set)
FCUA-CN211
(Note that when a one end connector
and contact are used, there is no
crimp terminal)
List of parts used
No. Part name/type
Connector
1
1-178288-3
Contact
2
1-175218-2
Wire material
MIX3CHRV-SV-SB
Twisted pair cable
3
with compound
3-pair shield.
Note (1)
Crimp terminal
4
V1.25-3
Crimp terminal
5
V1.25-5
Maximum cable length: 50m
1
2
3
Maker Qty.
Tyco
Electronics 2
AMP
Tyco
Electronics 6
AMP
TOA
Electric (1)
Industry
J. S. T 1
J. S. T 1
TXRX
TXRX*
LG
FG
2
).