Tesla Smart Robot Vacuum Cleaner Laser AI200 User Manual page 27

Is any power consumed if the vacuum cleaner always stays at the docking station?
Is it necessary to charge the battery for 16 hours when the vacuum cleaner is used for
the first three times?
The mopping module does not output water or the water output is small.
The power is insufficient during cleaning. After the vacuum cleaner returns to the
docking station for charging, it does not continue cleaning.
The vacuum cleaner cannot return to the docking station after partial cleaning or
after its position is moved.
The vacuum cleaner misses some areas when cleaning.
The power consumption is extremely low when the vacuum cleaner always stays at
the docking station. This helps to keep the battery in the best performance.
The lithium battery does not have a memory effect. It can be used instantly after it is
fully charged. There is no need to wait 16 hours.
Check whether there is any water in the water tank. Use the mobile app to set the
water output to the maximum value.
Install the mopping cloth and mop stand properly according to the manual.
Check whether the main unit is in DND mode. The vacuum cleaner will not continue
cleaning in DND mode.
The vacuum cleaner will not continue cleaning if the main unit is manually put back
to the docking station.
The vacuum cleaner will re-generate a map after partial cleaning or after it is moved
far away.
If the main unit is far away from the docking station, the main unit may fail to return
to the docking station by itself. In this case, manually put the main unit back to the
docking station.
The wall sensor or cliff sensor may get dirty. It is recommended that you wipe the
sensors using a soft dry cloth.
27
EN