Table of Contents
Advertisement
Page 16
3.6.2
Wiring Multiple AquaPure Units to a Jandy AquaLink RS
Only the master AquaPure unit can be connected to the AquaLink RS network. Additional AquaPure units
may be wired to the Filter Pump relay, but not to the AquaLink RS red, 4-pin terminal bar.
Section 4. Pool Water Preparation
ATTENTION INSTALLER: Various application notes (more detailed instructions) are
available from the Dealer covering installation, operation, maintenance, and plumbing
of the chlorinator system.
4.1 Determining Pool Size (m
• Rectangular Pools
Average length (meters) x average width (meters) x average depth (meters) = m
• Circular Pools
Diameter (meters) x diameter (meters) x average depth (meters) x 0.79 = m
• Oval Pools
Long diameter (meters) x short diameter (meters) x average depth (meters) x 0.79 = m
• Sloping Sides
Multiply total m
by 0.85 = m
3
4.2 Determining Pool Size (Gallons of Water in Your Pool)
• Rectangular Pools
Average length (feet) x average width (feet) x average depth (feet) x 7.5 = gallon capacity.
• Circular Pools
Diameter (feet) x diameter (feet) x average depth (feet) x 5.9 = gallon capacity.
• Oval Pools
Long diameter (feet) x short diameter (feet) x average depth (feet) x 5.9 = gallon capacity.
• Sloping Sides
Multiply total gallons by 0.85 = gallon capacity.
Never use dry acid to adjust pH in arid geographic areas with excessive evaporation and minimal
dilution of pool water with fresh water. A buildup of by-products can damage the electrolytic cell.
of Water in Your Pool)
3
capacity.
3
CAUTION
capacity.
3
capacity.
3
capacity.
3
Advertisement
Table of Contents
