User Tool Settings For Ieee 802.11A/G/N (Mf Model) - Ricoh SAVIN D0AP Service Manual

2412 - 2462 MHz (1 - 11 channels)
5180 - 5240 MHz (36, 40, 44 and 48 channels)
(default: 11)
In some countries, only the following channels are available: 2412 - 2462 MHz (1 -
•
11 channels)
For mainly North America
•
2412 - 2462 MHz (1 - 11 channels)
5180 - 5240 MHz (36, 40, 44 and 48 channels)
(default: 11)
13. Select [Security Method], and then press the [OK] key.
14. Specify the "Security Method" for encryption of the Wireless LAN. To not use security
setting, select [No].
• The "WEP" (Wired Equivalent Privacy) setting is for protecting wireless data
transmission. The same WEP key is required on the receiving side in order to unlock
encoded data. There are 64 bit and 128 bit WEP keys.
• Range of Allowed Settings:
64 bit: 10 characters
128 bit: 26 characters
• When "WPA2" is selected, authentication settings and certificate installation settings
are required.
When "Ad Hoc Mode" is selected, you cannot select WPA2 as the security method.
WPA2 Authent. Method:
•
Select either "WPA2-PSK" or "WPA2".
If you select "WPA2-PSK", enter the pre-shared key (PSK) of 8-63 characters in
ASCII code.
15. To check the connection status, enter [Wireless LAN Signal] in [Wireless LAN] and confirm
the signal status.
Press "Restore Factory Defaults" to initialize the wireless LAN settings.
2.16.4 USER TOOL SETTINGS FOR IEEE 802.11A/G/N (MF
MODEL)
Enter the User Tools mode and perform the procedure below. These settings take effect every
time the machine is turned ON.
• IEEE 802.11a/g/n function is disabled when using Ethernet.
1.
Press the [User Tools] icon.
2.
Select [Machine Features] > [System Settings] > [Interface Settings] > [Network] > [LAN
SM
IEEE 802.11 Interface Unit Type M24 (M500-08)
2-87 D0AP/D0C4/D0C5/D0C6/M0BQ/M0D1