Table of Contents
Advertisement
I R R E M O T E C O N T R O L
This unit can be operated using the ADJ UC IR24 remote control. The unit can only be controlled
when it has been set to Primary mode. The unit will NOT respond to commands when it has
been set to Secondary mode. When using the UC IR to control multiple units that are operating in
primary/secondary mode, follow these steps to set up the units:
1. Power on the unit, and press MODE to scroll to the "Personality" menu, then press ENTER.
2. Use the UP and DOWN buttons to scroll to "Prim/Sec Mode". Press ENTER, then use the UP and
DOWN buttons to toggle between "Primary" and "Secondary".
3. Press ENTER to confirm and return to the "Personality" menu.
4. Use UP and DOWN to scroll to "Wireless Settings" and press ENTER.
5. Use the UP and DOWN buttons select "Set Wireless Channel." Press ENTER and use UP and
DOWN to set the unit to your desired Wireless channel. Repeat these steps for each unit. Please
note that all units should be set to the same Wireless channel.
NOTES:
•
Only one unit should be configured as the primary, while all the other units should be configured as
secondaries.
•
All units in the system should be set to the same Wireless channel. If all units are set to the same
Wireless channel, and the units do not sync up and/or respond to commands, try using a different
Wireless channel.
•
All units should be set to the same DMX channel mode.
•
If fixtures fail to sync, verify that all settings mentioned above are the same, then power all devices
off, then switch them on again to re-establish the link.
C O N T R O L S
•
ON and OFF: When the ON button is pressed, the lighting fixture shall
return to its last running state. When the OFF button is pressed, the unit
shall go into stand by mode in a blackout state.
•
STROBE: The unit shall strobe the selected color or program. The strobe
rate can be adjusted with the + / - buttons. Buttons 0-15 are used to select
the color.
•
SOUND: Triggers the selected program steps based on sound input. The
microphone sensitivity can then be adjusted with the +/- buttons.
•
COLOR: When the color button is pressed, preset static colors can be
selected using buttons 0-15. The intensity for the set color can be adjusted
with the +/- buttons.
•
PROGRAM: When the program button is pressed, internal programs can
be selected by pressing buttons 0-15. The selected program's speed can
be adjusted with the+/- buttons.
•
+ and - buttons: These buttons are used to adjust strobe rate, mic sen-
sitivity, brightness intensity, or program run speed, depending on which
mode is active. Single-level adjustments can be made with individual buttons presses, while large
adjustments can quickly be made by press-ing and holding.
•
0-15 buttons: These buttons are used to select preset static colors or internal programs,
depending on which mode is active. Colors stored in buttons 0-15 can be edited from the units
menu if desired.
13
Advertisement
Table of Contents
