Uc Ir Control - ADJ UB 12H User Manual

U C I R C O N T R O L
The UC IR infrared remote gives the user control of various functions, as listed below. To control the
fixture, the remote must be aimed at the front of the fixture. Maximum range is 30 feet. To use the ADJ
UC IR, the fixture's infrared sensor must first be activated, as described in the Operating Instructions
section of this manual.
STAND BY - Press this button to blackout the fixture. Press again to return to the initial state.
FULL ON - Press this button to fully illuminate the unit. Press again to return to the unit back to its
previous state.
FADE/GOBO - Press this button to activate fade mode, then use buttons 1-3 to adjust fade speed.
"DIMMER +" and "DIMMER -" - Use these buttons to adjust the output intensity.
STROBE - Press this button to activate strobing. Use buttons 1-4 to adjust the strobe speed. "1" is the
slowest, and "4" is the fastest. Press this button again to deactivate strobing.
COLOR - Press this button to activate color mode. Use buttons 1-9 to find your desired color.
1-9 - Use buttons 1-9 to select your desired color when in color mode, or your desired program when in
show mode. Use buttons 1-4 to select your desired strobe speed when in strobe mode.
SOUND ON & OFF - Use the buttons to activate and deactivate sound active mode.
SHOW 0 - Press this button to activate show mode. Use buttons 1-9 to select your desired show. Press
this button twice for show 10. Press button 1 twice for show 11.
16