Battery: In-Case Charging - ADJ ELE600 User Instructions

B AT T E R Y: I N - C A S E C H A R G I N G
1. Lock the wheel casters by pressing down on the levers located near each caster.
2. Disengage the two latches and raise the case lid.
3. Once the lid has been opened, lift the upper end of the support bar and attach it to the recessed
catch on the underside of the lid, along the right-hand side. Make sure that the catch is fully seated
in the support bar's groove before reaching into the flight case. Please refer to Safety Guidelines
section of this manual for detailed information.
4. Connect the included power cable into the Power-In port. If power linking cases together, please
refer to the Daisy Chain Power Linkage section of this manual for details.
5. Place an ADJ Element H6 fixture in any one of the charging compartments in the flight case. Up
to (6) units can be charged at one time. The charging indicator located beside the power ports will
illuminate to indicate that your device is charging. It is strongly recommended to leave the case
lid open during the charging process.
18