Table of Contents
Advertisement
C L E A N I N G & M A I N T E N A N C E
WARNING! DISCONNECT UNIT FROM POWER BEFORE PERFORMING ANY CLEANING OR
MAINTENANCE PROCEDURES!
ALWAYS ALLOW THE FIXTURE TO COOL FOR AT LEAST 15 MINUTES BEFORE PERFORMING
ANY CLEANING OR MAINTENANCE!
CLEANING
Frequent cleaning is recommended to ensure proper function, optimized light output, and an
extended life. The frequency of cleaning depends on the environment in which the fixture operates:
damp, smoky, or particularly dirty environments can cause greater accumulation of dirt on the fixture's
optics. Clean periodically with a soft cloth to avoid dirt/debris accumulation.
NEVER use alcohol, solvents, or ammonia-based cleaners.
MAINTENANCE
Regular inspections are recommended to ensure proper function and extended life. There are no user
serviceable parts inside this fixture. Please refer all other service issues to an authorized ADJ service
technician. Should you need any spare parts, please order genuine parts from an authorized ADJ
dealer.
Please refer to the following points during routine inspections:
•
A detailed electrical check by an approved electrical engineer every three months, to make sure
the circuit contacts are in good condition and prevent overheating.
•
Be sure all screws and fasteners are securely tightened at all times. Loose screws may fall out
during normal operation, resulting in damage or injury as larger parts could fall.
•
Check for any deformations on the housing, color lenses, rigging hardware and rigging points
(ceiling, suspension, trussing). Deformations in the housing could allow for dust to enter into the
fixture. Damaged rigging points or unsecured rigging could cause the fixture to fall and seriously
injure a person(s).
•
Electric power supply cables must not show any damage, material fatigue or sediments.
D A I S Y C H A I N P O W E R L I N K A G E
This feature allows multiple flight cases to be linked together by way of the power input and output
sockets. The maximum number of devices that can be connected in this manner is as follows:
•
4 flight cases using a 15-Amp plug.
•
5 flight cases using a 20-Amp plug.
After this quantity has been reached, a new power outlet must be used to accommodate additional
charging cases.
It is recommended to leave the case lids open when charging in order to avoid the accumulation of
excess heat inside the cases.
Linked devices must be of the same make and model type. DO NOT mix devices!
33
Advertisement
Table of Contents
