Table of Contents
Advertisement
W I R E L E S S S E T U P
This device does not feature physical DMX connector ports. Therefore, in order to utilize DMX
control, the user must first set up the device to run wireless DMX control. Follow the directions
below to configure wireless DMX control:
1.
First, select the DMX Channel Mode for that you would like the device to operate in. Press MODE
until the the "DMX Settings" menu is displayed on the screen. Use the UP or DOWN buttons to scroll
to "DMX Channel Mode," then press the SETUP button.
2.
Use UP or DOWN to scroll through the DMX Channel Mode options, then press SETUP to con-firm
your selection.
3.
Next, enable the device's Wireless capability. Press MODE until the "Personality" menu is displayed
on the screen, then use UP or DOWN to scroll to "Wireless Settings" and press SETUP.
4.
Use UP or DOWN to scroll to "Enable Wireless," then press SETUP to select this option.
5.
Use UP or DOWN once again to toggle this setting to "Yes," then confirm by pressing SETUP.
6.
Next, select the Wireless channel. Press MODE until the "Personality" menu is displayed on the
screen again, then use UP or DOWN to scroll to "Wireless Settings" and press SETUP.
7.
Use UP or DOWN to scroll to "Set Wireless Channel," then press SETUP again.
8.
Now use UP or DOWN to scroll to your desired Wireless channel. Selectable values range from 00
to 15.
9.
Finally, set the DMX address. Press the MODE button until the "DMX Settings" menu is displayed on
the screen, then use UP or DOWN to scroll to "DMX Address," then press SETUP.
10. Use the UP or DOWN buttons to scroll to your desired DMX address, then press SETUP to confirm
your selection. Available values range from 001 to 512. Refer to the DMX Addressing section of this
manual for detailed guidance. Repeat these steps for each individual unit that you wish to use.
There are many factors that can affect and/or interrupt a wireless signal, including walls, glass, metal,
objects, and people. Therefore, the following guidelines are recommended in order to maximize the
chances of having a clear path for the wireless signal to reach the device:
•
Install the device a minimum of 9.8 ft (3m) above audiences and/or ground level.
•
Arrange the wireless antenna in an upright, vertical position.
•
Position devices in direct line of sight of the transmitting controller.
Careful planning and testing of the selected installation location is critical to ensure optimum and
reliable wireless operation.
12
Advertisement
Table of Contents
