Installation - ADJ ELE600 User Instructions

I N S TA L L AT I O N
IP RATING
The ELEMENT H IP is IP54 rated. Ingress of dust is not entirely prevented, but it will not enter in sufficient
quantity to interfere with satisfactory operation of the device. The ELEMENT H IP is also protected
against splashing water from any direction. WHILE SOME DEGREE OF WATER RESISTANCE IS
PRESENT, THE ELEMENT H IP FIXTURE IS NOT INTENDED FOR OUTDOOR USE. Please note
that the charging components are not IP-rated at all, and are intended for use in dry, indoor
conditions only.
FLAMMABLE MATERIAL WARNING!
Keep device a minimum of 5.0 feet (1.5m) away from flammable material and/or pyrotechnics.
ELECTRICAL CONNECTIONS
A qualified electrician should be used for all electrical connections and/or installations.
DO NOT INSTALL THE DEVICE IF YOU ARE NOT QUALIFIED TO DO SO!
The unit MUST be installed following all local, national, and country commercial electrical and
construction codes and regulations.
Before installing or mounting any device, a professional equipment installer MUST be consulted to
determine whether the mounting structure or surface is properly certified to safely support the combined
weight of the fixture, clamps, cables, and accessories.
Maximum operating temperature 113 degrees F (45 degrees C). Do not operate the device if ambient
temperatures exceeds this value.
This fixture should be installed away from walking paths, seating areas, and areas where unauthorized
personnel might be able to reach the device by hand.
NEVER stand directly below the fixture when rigging, removing, or servicing.
Allow approximately 15 minutes for the fixture to cool down before servicing.
14