Table of Contents
Advertisement
CHAP.08 USE AND MAINTENANCE FOR THE USER
08.1
APPLIANCE OPERATIONS
The STOVE uses pellets as fuel, whose combustion is electronically controlled.
Pellets are taken from the storage hopper by the auger controlled by the gear motor and conveyed directly to the burn pot. They are
ignited by the hot air produced by the electric heating element (E) and aspirated into the burn pot by the centrifugal fan which is the same
that sucks up the fumes produced by combustion, expelling them to the rear part of the stove.
The room air tangential fan moves the air into the space on the back of the fireplace, where it is heated and then released into the
environment through the front outlet. Located on the rear part of the stove, the hopper is filled by an openable lid located on the upper
part of the cladding. Pellets must be placed in the hopper with a shovel and not directly poured from the bag.CHAP. 08.6 ORDINARY
MAINTENANCE (By the customer).
The fireplace is equipped with an exchanger in steel and dual heat developing FIREFLECTOR, closed in front by a door in ceramic glass.
The quantity of fuel, the feeding of comburent air and the extraction of fumes are regulated with an electronic card in order to obtain a
highly efficient combustion.
All the operations for managing machine functions are handled by the supplied radio remote control (see manual SM116 attached).
08.2
CONTROL UNIT
The electronic control unit, connected by radio frequency to the radio remote control, manages all the device functions and the LCD
display screen on the handheld console can be used to monitor all the stove operating phases.
The electronic control unit features a timer function with customisable programmes and a user-friendly operating settings. Operations
are controlled by the ROOM PROBE in the remote control or standard installed at the back of the appliance, that can be prolonged to
the installation room in a more appropriate position to correctly measure room temperature. It can be used as an ambient thermostat,
paying GREAT ATTENTION that the electrical connection to the stove motherboard is CLEAN
The electric/electronic elements also include certain safety systems such as:
FUME TEMPERATURE PROBE
PRESSURE SWITCH
SAFETY THERMOSTAT
The radio remote control lets you use the following main functions:
NOTE
For a full and detailed description of the content in this section, see the enclosed manual SM116.
Fitted inside the fume exhaust fan
Connected to the lower pat of the appliance flue-gas pass
Triggers when temperature in the appliance is too high
•
Device start and stop
•
Heat output level control
•
Regulate the desired ambient temperature.
•
Optimise combustion.
•
Manually load pellets into the basket.
•
Manage the timed thermostat with several daily start ups, weekly start ups
and for week-ends.
•
Report any function irregularities.
•
Indicate the heating appliance's operating mode.
In the event of radio remote control fault, main appliance functions can be
controlled from the emergency console.
25
Advertisement
Table of Contents
