Primary Encoder Inputs; Table 2-15: Multiplier Options; Table 2-16: Primary Encoder Pins On The Feedback Connector - Advantech Automation1 iXC4 Hardware Manual

Hardware Manual

2.3.1. Primary Encoder Inputs

The primary encoder inputs are accessible through the Feedback connector. Use the
PrimaryFeedbackType [A3200: PositionFeedbackType or VelocityFeedbackType] parameter to
configure the drive to accept an encoder signal type.
Square Wave encoder signals:
Absolute encoder signals:
Sine Wave encoder signals (as permitted by the multiplier option):
You cannot use a sine wave encoder with the -MX1 multiplier option as an input to the PSO. The -
MX1 option does not generate emulated quadrature signals.
Refer to Section 2.3.1.4.
Refer to Section 2.5.
Table 2-15: Multiplier Options
Option Primary Encoder Accepts...
-MX0 Square Wave or Absolute encoders
Sine Wave, Square Wave, or Absolute
-MX1
encoders
IMPORTANT: Physically isolate the encoder wiring from motor, AC power, and all other
power wiring
Table 2-16: Primary Encoder Pins on the Feedback Connector
Pin # Description
+5V Power
3
Encoder Marker Reference Pulse -
6
Absolute Encoder Clock -
Encoder Marker Reference Pulse +
7
Absolute Encoder Clock +
8 Absolute Encoder Data -
14 Encoder Cosine +
15 Encoder Cosine -
+5V Power
16
17 Encoder Sine +
18 Encoder Sine -
19 Absolute Encoder Data+
20 Signal Common
21 Signal Common
(1) The maximum combined current output is 500 mA.
www.aerotech.com
Section 2.3.1.1.
Section 2.3.1.2.
for encoder feedback phasing.
for the auxiliary encoder on the Aux I/O connector.
(1)
(1)
Section 2.3.1.3.
Auxiliary Encoder Accepts...
Square Wave or Absolute encoders
Square Wave or Absolute encoders
In/Out/Bi
Bidirectional
Bidirectional
iXC4/XC4
Output
Input
Output
Input
Output
Input
Input
Output
Input
Input
Output
Output
45