Port Leds - Cisco IE 4010 Hardware Installation Manual

Product Overview
11
12
13
14

Port LEDs

Each Ethernet port has a port LED. These port LEDs, display information about the individual ports. The port
mode determines the type of information shown by the port LEDs. The following table lists the mode LEDs
and their associated port modes and meanings
Table 3: Port Mode LEDs
Mode LED
All Off
SPEED
DUPLX
REDUN
SYNCE
PoE
To select or change a mode, press the Mode button until the desired mode is highlighted. The Mode LED will
turn ON solid green when a mode is selected and turn OFF when timeout (5 seconds) or a different mode is
selected. When you change port modes, the meanings of the port LED colors also change. The following table
explains how to interpret the port LED colors in different port modes.
Synchronous Ethernet status
PoE
Display mode switch
SD card slot cover
Port Mode
Port status
Port speed
Port duplex mode
Redundancy status
Synchronous Ethernet status
PoE+ port power
Cisco IE 4010 Switch Hardware Installation Guide
Description
The port status. This is the default mode.
The port operating speed: 10, 100, 1000 mbps or
10 Gbps.
The port duplex mode: full duplex or half duplex.
Parallel Redundancy Protocol (PRP) status.
Not supported by software yet. Mode button skips
this LED.
The PoE+ port status.
Port LEDs
7