Rack-Mounting; Attaching Brackets For 19-Inch Racks - Cisco IE 4010 Hardware Installation Manual

Rack-Mounting

• Wall-Mounting
Rack-Mounting
To rack-mount the switch, select the rack size and follow the steps in these sections:
Warning
Warning

Attaching Brackets for 19-Inch Racks

The following illustrations show how to attach brackets to the switches.
Figure 7: Attaching Brackets for 19-Inch Racks (Front bracket)
Cisco IE 4010 Switch Hardware Installation Guide
18
To prevent bodily injury when mounting or servicing this unit in a rack, you must take special precautions to
ensure that the system remains stable. The following guidelines are provided to ensure your safety:
This unit should be mounted at the bottom of the rack if it is the only unit in the rack.
When mounting this unit in a partially filled rack, load the rack from the bottom to the top with the heaviest
component at the bottom of the rack.
If the rack is provided with stabilizing devices, install the stabilizers before mounting or servicing the unit in
the rack. Statement 1006
For mounting railway-application equipment and for EN50155 standard compliance, the switch must be
installed only in a rack mid-mounting position. If you install the switch in a front rack-mounting (cable side
or power supply side) position or in a wall-mounting position, a mechanical failure can occur that results in
the switch becoming detached from the rack. Statement 403
Switch Installation