Table of Contents
Advertisement
5 - INSTALLATION
5.1 - INSTALLATION
PPE MUST bE WORN
Handle the product with the utmost care and wear suitable personal protective
equipment compliant with legal standards.
WARNING
before connecting the appliance, make sure that the mains voltage is the same
as
stated on the appliance rating plate or on the
rating plate of the compressor.
When positioning the refrigerating unit (on refrigerating units with remote refrigerating unit),
proceed with care to prevent the occurrence of blockages or breakages along the connecting
pipes.
Always ensure that the refrigerator and remote
refrigerating unit (where supplied) are installed
on a flat surface (Fig. 5.1.1).
Make sure that the refrigerating unit has enough
ventilation by cutting two holes in the cupboard
that will accommodate the refrigerator: one at
the bottom next to the refrigerating unit and the
second in the top or on the upper half of the side
(Fig, 5.1.2).
The openings must have an area of at least 300 cm². If this is not possible, leave a gap of at
least 50 mm between the refrigerator top and the top above it.
Create two side air vents, as shown in the figure.
EN
Fig. 5.1.1
57
Advertisement
Table of Contents
