Table of Contents
Advertisement
6.3 – MAINTENANcE MODE
During maintenance operations, the ice-making operations are interrupted. The machine
enters maintenance mode when:
•
The ice maker on switch (Fig. 6.3.1) is off.
•
Hopper (Fig. 6.3.1) full of ice. To restart the ice maker simply empty the hopper, even
partially).
PLEASE NOTE:
The ice cube rack in the top drawer (Fig. 14, c) has an ON/OFF switch to start
the ice-making process. When the Ice Maker drawer is open, the ice maker will
stop automatically. (See attached wiring diagram).
Fig.
7 – ROUTINE MAINTENANcE
WARNING
before carrying out any maintenance on the equipment, make sure that:
- the fridge is off: see the on-off control "
- The equipment is disconnected from power sources.
- The temperature of the different parts is as close as possible to the ambient
temperature.
- Wear personal protective equipment (PPE), in line with regulations.
–
7.1
cLEANING ThE REFRIGERATOR
Exterior
Clean the outside of the appliance with a soft cloth or sponge, without using solvents or
abrasive products.
Interior
Remove one sliding drawer at a time and proceed to clean using warm water mixed with a
little bicarbonate of soda or vinegar.
Rinse carefully and dry thoroughly using a soft cloth. Never use abrasive products, detergents
or soap.
In the case of prolonged disuse, to avoid the formation of mould or unpleasant odours,
disconnect the appliance from the mains power, removing the plug from the socket; empty the
unit completely; clean the interior, and leave the door ajar.
condenser
The condenser should be cleaned at least once a year using a vacuum cleaner or a dry brush.
6.3.1
O
A4
" .
EN
69
Advertisement
Table of Contents
