Table of Contents
Advertisement
7.2 – DEFROSTING ThE APPLIANcE
PLEASE NOTE:
Defrosting should be carried out whenever the frost layer exceeds a thickness
of three millimetres. This is necessary to guarantee efficient refrigeration and
to avoid excessive power consumption.
For total appliance defrosting:
•
Press the on-off button "
•
Leave the drawers open to speed up the defrosting time.
•
Do not attempt to remove the frost layer using sharp metal instruments. This could pierce
the refrigerator plate and cause irreparable damage to the appliance.
WARNING
Failure to comply with the above could cause damage to the refrigerating
circuit.
•
At the end of the defrosting process, switch on the machine "
7.3 – DRAWER REMOVAL
To remove the drawers, it is necessary to press down on the levers (Fig. 7.3.1) that you will find on
the right or left-hand guide (Fig. 7.3.1), releasing the lock of the drawer.
EN
PLEASE NOTE:
opposite direction to that of the one on the right (Fig. 7.3.1).
Fig.
7.4 - LIGhT LED bOARD REPLAcEMENT
The refrigerators in the DW series have LED lights, magnetically controlled by the drawers
opening or closing. Modules with two drawers have two LED bars: one under the top of the unit
for the top drawer and one under the central crosspiece for the bottom one. Modules with just
one drawer and the ventilate fridge have a LED light bar over the top of the unit. When the door
is opened on the ventilated fridge, this causes the light to switch on and the evaporator fan to
stop, restarting once the door is closed.
•
remove the protective cover perpendicularly from the base. Take care not to damage the
fastening pins.
•
disconnect the light power supply cord
•
replace the LED light board
70
" to switch off the appliance.
The guide on the left is unlocked by pressing the lever in the
7.3.1
I
To replace the lighting board, proceed as follows:
"
Advertisement
Table of Contents
