Table of Contents
Advertisement
Available languages
Available languages
INSTALLATION
It is advisable to clean the inside of the absorption refrigerator with lukewarm water using a mild detergent, and
then to dry it thoroughly prior to use.
The temperature in the appliance will depend on:
The temperature in the room
The frequency and duration of periods when the door is open.
How many items are in the fridge
It may therefore be necessary to adjust the thermostat from time to time.
The refrigeration system of the cabinet is designed to operate with the cabinet located on a flat surface. Avoid
tilting the cabinet side.
If the cabinet must be tilted on an angle for handling or moving purposes, allow it to sit in an upright position 20 to 30
minutes prior to plugging it in and starting the cooling of the storage compartment.
Grounding plug and socket should be provided in accordance with local regulations. The cable-size should meet the
refrigerator's requirements. The unit must be connected to proper electrical network, which is shown on the nameplate,
through an omnipoplar circuit-breaker. To assure the proper function of the refrigerator, please observe the following
recommended.
1.
To ensure the circulation, it is necessary to abide by the instructions in the "installation drawing" (see below) and
leave a gap of 20 mm between the refrigerator and the side walls.
2.
Locate the unit away from direct sunlight. This will enable you to obtain the best performance and save energy.
3.
The ventilation grilles need to be at least as wide as the refrigerator and no less than 50 mm high.
Installation Figure (side view of the refrigerator)
Pag.
11
Advertisement
Table of Contents
