Table of Contents
Advertisement
6.1.2 - "FINE" ADJUSTMENT FOR WATER SUPPLY (version with
ice maker)
To access the screw to adjust the incoming water level, remove the plastic casing from the ice maker
(Fig. 13, A).
Use a screwdriver on the water level adjustment screw (Fig. 13, b) to move the contact directly
on the grid assembly.
- Turn the screw clockwise:
- Turn the screw anticlockwise:
A full turn (360°) will increase/reduce water by 40 cm³ (~2.4 sec.)
A half turn (180°) will increase/reduce water by 20 cm³ (~1.2 sec.)
PLEASE NOTE:
After it has been installed, the Ice Maker will run an empty cycle and then
produce ice during all subsequent cycles.
The first cubes will be dispensed after approximately 1 hour.
EN
6.2 - IcE MAKING MODE (version with ice maker)
- Production
The base of the grid assembly is filled with water and the thermostat re-
mains in the open position.
Once the set temperature has been reached, the cycle for ice ejection from
the grid assembly (J) (~ 40 min.) will begin.
- Ejection
Once at the correct temperature, the thermostat will close, starting the
1
heating element and the motor.
Extractor blades will press down on the ice to remove it;
2
the heating element remains on
The blades extract the ice cubes from their seating, pouring them into
3
the rack.
The ice-making cycle will continue until the ice hopper is full
68
A
to reduce the amount of water
to increase the amount of water
O
B
6.1.2.1
Fig.
A4
Advertisement
Table of Contents
