Table of Contents
Advertisement
Replacing the optical-drive eject-button board
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow the steps
in
Before working inside your
computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/regulatory_compliance.
Topics:
•
Procedure
•
Post-requisites
Procedure
1. Align and place the optical-drive eject-button board, along with the cable on the chassis.
2. Replace the two screws (#6-32x6) that secure the optical-drive eject-button board to the chassis.
3. Secure the optical-drive eject-button board cable to the chassis using the securing clips.
4. Connect the optical-drive eject-button board cable to the I/O board.
Post-requisites
1. Replace the
front
bezel.
2. Replace the
handle
bars.
3. Replace the left and right side-panels. See
4. Replace the
stability
foot.
computer. After working inside your computer, follow the instructions in
"Replacing the side
panels".
After working inside your
101
Advertisement
Table of Contents
