Table of Contents
Advertisement
Removing the battery case
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow the steps
in
Before working inside your
computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/regulatory_compliance.
Topics:
•
Prerequisites
•
Procedure
Prerequisites
1. Remove the
stability
foot.
2. Remove the right side-panel. See
3. Remove the battery.
Procedure
1. Lay the chassis on the left side.
2. Press the release tabs on the cable connector to disconnect the battery-case cable from the I/O board.
3. Remove the two screws (#6-32x5.2) that secure the battery case to the chassis.
4. Lift the battery case off the chassis.
26
computer. After working inside your computer, follow the instructions in
"Removing the side
panels".
After working inside your
Advertisement
Table of Contents
Need help?
Do you have a question about the Alienware Area-51 R3 Threadripper Edition and is the answer not in the manual?