Chapter 55: Removing The Handle Bars; Prerequisites; Procedure - Dell Alienware Area-51 R3 Threadripper Edition Service Manual

Removing the handle bars
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow the steps
in Before working inside your
computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/regulatory_compliance.
Topics:
•

Prerequisites

•

Procedure

Prerequisites
1. Remove the stability foot.
2. Remove the left and right side-panels. See
Procedure
1. Remove the seven screws (#6-32x6.5) that secure the rear handle-bar to the left side of the chassis.
a. screws (7)
b. chassis
c. rear-handle bar
2. Remove the seven screws (#6-32x6.5) that secure the rear handle-bar to the right side of the chassis.
3. Press the rear-handle bar to release the securing tab and remove the rear-handle bar.
computer. After working inside your computer, follow the instructions in
"Removing the side panels".
After working inside your
91