Table of Contents
Advertisement
Visual and daily maintenance inspections
3
4.2-8 Platform assembly
Do the inspection that follows in sequence:
WARNING
Fall hazard. Use the three points of contact
principle when you enter or exit the platform. If
you do not obey, there is a risk of death or serious
injury.
1. Enter the platform
2. Close the gate or drop bar.
Platform railings
1
Make sure there are no loose or missing parts,
▪
and there is no visible damage.
Make sure the fasteners are correctly installed.
▪
Make sure the platform railings
▪
correct position.
Make sure the gates or drop bars
▪
good condition and operate correctly.
Fall-protection anchorages
3
Make sure that the fall-protection anchorages
▪
are correctly installed.
Make sure there is no visible damage.
▪
Footswitch
4
Make sure the footswitch is in good working
▪
order and has not been tampered with,
disabled or blocked.
SJ63 AJ+
7
8
are in the
1
are in
2
Section 4 – Inspections Before Operation
6
1
5
4
2
MEWP floor
5
Make sure the MEWP floor is solid and there is
▪
no visible damage.
AC power socket
6
Make sure that the socket is free of dirt or
▪
blockages.
Platform control console
7
Make sure all switches and controllers are in
▪
the neutral position.
Make sure there are no loose or missing parts,
▪
and there is no visible damage.
Manual storage box
8
Make sure that the operation manual and
▪
other important documents are in the manual
storage box.
Make sure that the documents are in good
▪
condition, and you can read them.
Always put the manuals and other documents
▪
back in the storage box after use.
3. Exit the platform.
3
213211AAA
47
Advertisement
Table of Contents
