Table of Contents
Advertisement
PoE Web Smart Switch Series
TRENDnet User's Guide
ARP Inspection Port Settings
Security > Dynamic ARP Inspection > ARP Settings
1. Log into your switch management page (see "Access your switch management page"
on page 5).
2. Click on Security, click on Dynamic ARP Inspection, and click on ARP Inspection Port
Settings.
3. Select the Port then its Trust State. Click apply to save.
4. At the bottom of the left hand panel, click Save.
5. Select the Config you would like to save the settings to, then click Save Settings to
Flash.
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.
© Copyright 2023 TRENDnet. All Rights Reserved.
108
Advertisement
Table of Contents
