Arp Inspection Port Settings; Arp Inspection Vlan - TRENDnet Web Smart Switch Series User Manual

TRENDnet User's Guide

ARP Inspection Port Settings

Security > Dynamic ARP Inspection > ARP Settings
1. Log into your switch management page (see
on page 5).
2. Click on Security, click on Dynamic ARP Inspection, and click on ARP Inspection Port
Settings.
3. Select the Port then its Trust State. Click apply to save.
4. At the bottom of the left hand panel, click Save.
5. Select the Config you would like to save the settings to, then click Save Settings to
Flash.
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.
© Copyright 2023 TRENDnet. All Rights Reserved.
"Access your switch management page"

ARP Inspection VLAN

Security > Dynamic ARP Inspection > VLAN
1. Log into your switch management page (see
on page 5).
2. Click on Security, click on Dynamic ARP Inspection, and click on ARP Inspection VLAN
3. Select the VID List then its State. Click apply to save.
4. At the bottom of the left hand panel, click Save.
5. Select the Config you would like to save the settings to, then click Save Settings to
Flash.
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.
Web Smart Switch Series
"Access your switch management page"
98