Interfaces; Binding - TRENDnet TPE-30284 User Manual

TRENDnet User's Guide

Interfaces

Security > DHCP Snooping > Interfaces
This section allows you to set trusted port interfaces where DHCP servers can be
connected allows or denies DHCP server information to be received on those ports.
1. Log into your switch management page (see "Access your switch management page"
on page 5).
2. Click on Security, click on DHCP Snooping, and click on Interfaces.
3. Next to each port, click the Trust drop-down list and select one of the following
options.
•
Disable: This parameter defines the port as untrusted for the DHCP Snooping
feature.
•
Enable: This parameter defines the port as trusted for the DHCP Snooping
feature.
Note: You can select the row labeled ALL to apply settings to all ports.
4. At the bottom of the left hand panel, click Save.
5. Select the Config you would like to save the settings to, then click Save Settings to
Flash.
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.
© Copyright 2023 TRENDnet. All Rights Reserved.

Binding

Security > DHCP Snooping > Binding
The Binding Database displays learned and statically assigned MAC
Address and IP Address information for each host on the local area network.
Dynamically assigned IP addresses from the DHCP server will automatically populate the
table on the Binding Database page as they are assigned by the server. Statically
assigned IP addresses are entered manually by entering the host's address information
and clicking on the Add button.
1. Log into your switch management page (see "Access your switch management page"
on page 5).
2. Click on Security, click on DHCP Snooping, and click on Binding.
3. Review the settings. Click Add to add the database entry to the table.
•
MAC Address - Enter the host's MAC Address.
•
IP Address - Enter the static IP Address assigned to the host.
•
VLAN - Enter the host's VLAN ID.
•
Port - Enter the port number where the host is connected.
•
Type - Because the IP Address being entered is static, you must select Static.
•
Lease Time - Enter the time that IP address assignment is valid. The range is 10
to 4294967295 seconds.
PoE Web Smart Switch Series
105