Table of Contents
Advertisement
TRENDnet User's Guide
NOTE: The configured settings are only applied to the switch's temporary memory and
will be lost upon the next power-cycle. Please follow these next steps to save the
configurations to the switch's NV-RAM to ensure the settings will remain throughout
power-cycles and reboots:
1. From the menu on the left: click on Save, then click the blue button Save
Settings to Flash.
2. Click Continue to return to the Web Configuration of your switch.
Configure Spanning Tree Protocol port settings
Network > Spanning Tree > RSTP Port Settings
1. Log into your switch management page (see
on page 7).
2. Click on Network, click on Spanning Tree, and click on RSTP Port Settings.
© Copyright 2018 TRENDnet. All Rights Reserved.
"Access your switch management
page"
3. Review the settings. For each entry, click Apply to save changes.
Port - Specifies the port number. The All value indicates ports 1 through 5 on
the Switch. You cannot change this parameter. You can use the All row value in
the Port column to apply the Port Fast setting across all ports.
Port Fast – Select the type of network that this port is connected to and
whether to enable spanning tree for the specified port.
o
Network – STP enabled and the port is connected to the main
network.
o
Disabled – Disables STP on this port.
o
Edge – STP enabled and indicates if a port is connected to an edge
device in the network topology or not. Edge ports cannot create loops,
however an edge port can lose edge port status if a topology change
creates a potential for a loop. An edge port normally should not
receive BPDU packets. If a BPDU packet is received, it automatically
loses edge port status.
NOTE: The configured settings are only applied to the switch's temporary memory and
will be lost upon the next power-cycle. Please follow these next steps to save the
configurations to the switch's NV-RAM to ensure the settings will remain throughout
power-cycles and reboots:
TEG-S50ES
21
Advertisement
Table of Contents
