Events - TRENDnet TPE-30284 User Manual

TRENDnet User's Guide

Events

System > RMON > Event
An event specifies the action of the switch when the ingress packet activity on a port
crosses a statistical threshold defined in an alarm. The choices are to log a message in
the event log of the switch, send an SNMP trap to an SNMP workstation, or both. Since
there are only three possible actions and since events can be used with more than one
alarm, you probably will not create more than three events - one for each of the three
actions.
1. Log into your switch management page (see "Access your switch management page"
on page 5).
2. Click on System, click on RMON, and click on Event.
3. Review the settings.
•
Index: This parameter specifies the ID number of the new group. The range is 1
to 65535.
•
Description: This parameter specifies a text description of the event that you
are configuring.
•
Type: This parameter specifies where to log the event when it occurs. The
choices are to log a message in the event log of the Switch, send an SNMP trap
to the SNMP NMS software, or both.
•
Community: This parameter specifies the community where you want to send
the SNMP trap.
•
Owner: This parameter is used to identify the person who created an entry. It is
primarily intended for switches that are managed by more than one person,
and is an optional field.
© Copyright 2023 TRENDnet. All Rights Reserved.
Click Add to add the entry to the table.
In the list, you can click Modify to modify an entry or click Delete or delete the entry.
You can also click Delete All to delete all of the entries in the table. If the entries span
multiple pages, you can navigate page number in the Page field and click Go or you can
click First, Previous, Next, and Last Page to navigate the pages.
4. At the bottom of the left hand panel, click Save.
5. Select the Config you would like to save the settings to, then click Save Settings to
Flash.
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.
PoE Web Smart Switch Series
44