Dynamic Arp Inspection; Settings - TRENDnet TPE-30284 User Manual

TRENDnet User's Guide
In the list, you can click Modify to modify an entry or click Delete or delete the entry.
You can also click Delete All to delete all of the entries in the table. If the entries span
multiple pages, you can navigate page number in the Page field and click Go or you can
click First, Previous, Next, and Last Page to navigate the pages.
•
MAC Address: This parameter shows the host's MAC Address.
•
VLAN ID: This parameter shows the host's VLAN ID of which the DHCP client is
a member.
•
IP Address: This parameter is the IP Address assigned by the DHCP server to
the DHCP client.
•
Port: This parameter is the port number where the DHCP client is connected.
•
Type: This parameter indicates the following:
•
Learned-The host IP Address is dynamically assigned by the DHCP server.
•
Static- The host IP Address is statically assigned. See "Static IP Addresses" on
page 300 for more information.
•
Lease Time: This parameter is the time that IP address assignment by the DHCP
server is valid.
4. At the bottom of the left hand panel, click Save.
5. Select the Config you would like to save the settings to, then click Save Settings to
Flash.
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.
© Copyright 2023 TRENDnet. All Rights Reserved.

Dynamic ARP Inspection

Settings

Security > Dynamic ARP Inspection > ARP Access List
1. Log into your switch management page (see "Access your switch management page"
on page 5).
2. Click on Security, click on Dynamic ARP Inspection, and click on ARP Access List.
3. Enter a name for the List. Click Apply to save the settings.
4. At the bottom of the left hand panel, click Save.
5. Select the Config you would like to save the settings to, then click Save Settings to
Flash.
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.
PoE Web Smart Switch Series
106