Time Settings - TRENDnet TPE-30284 User Manual

TRENDnet User's Guide

Time Settings

Network > GVRP > Time Settings
This section will allow you to define the GARP Join, Leave, and Leave All Time for each
port.
Note: The GARPLeaveTimer must be greater than (GARPJoinTimer x2 + 10) and the
GARPLeaveAllTimer must be greater than (GARPLeaveTimer + 10). The acceptable input
values are multiples of 10. If you try to enter a value that is not a multiple of 10, the
value is rounded down
1. Log into your switch management page (see "Access your switch management page"
on page 5).
2. Click on Network, click on GVRP and click on Time Settings.
3. Review the settings for each port. Click Apply to save the settings.
•
Port - This parameter displays the ports on the switch.
•
JoinTime - This parameter is the GARP Join Timer. Its range is 10 - 1073741810
milli-seconds.
•
LeaveTime - This parameter is the GARP Leave Timer. Its range is 30 -
2147483630 milli-seconds. This timer must be set in relation to the GVRP Join
Timer according to the following equation:
GARPLeaveTimer >= (GARPJoinTimer X 2) + 10
•
LeaveAllTime - This parameter is the GARP Leave All Timer. Its range is 40 -
2147483630 milli-seconds. This timer must be set in relation to the GVRP Leave
Timer according to the following equation:
GARPLeaveAllTimer > (GARPLeaveTimer + 10)
Note: To ensure compatibility between network devices, you need
to configure the same values for the GARP Join Timer, GARP Leave Timer, and GARP
Leave All Timer on all participating GVRP devices in your network.
© Copyright 2023 TRENDnet. All Rights Reserved.
4. At the bottom of the left hand panel, click Save.
5. Select the Config you would like to save the settings to, then click Save Settings to
Flash.
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.
PoE Web Smart Switch Series
76