Mst - TRENDnet TPE-30284 User Manual

TRENDnet User's Guide

MST

Network > Spanning Tree > MST
1. Log into your switch management page (see "Access your switch management page"
on page 5).
2. Click on System, click on Spanning Tree, and click on MST.
3. Review the settings. For each section, click Apply to save changes.
MST Configuration Identification Settings
•
Configuration Name: A configured name set on the switch to uniquely identify
the MSTI (Multiple Spanning Tree Instance). If a configuration name is not set,
this field shows the MAC address of the device running MSTP.
•
Revision Level (0-65535): This value, together with the configuration name,
and identical vlans mapped for STP instance IDs identifies the MST region
configured on the switch.
MST Instance Settings
•
MSTI ID (1 - 31): Displays the MSTI ID associated with the VID List. The possible
field range is 1-31.
•
VID List (1 - 4094): Displays the VID List. Click Add to add into MST Table below.
•
Priority: Enter the new priority in the Priority field. The user may set a priority
value between 0-61440.
© Copyright 2023 TRENDnet. All Rights Reserved.
•
MST Table: Make changes to the table entry, and click Apply modify or click
Delete to remove the ID entry.
4. At the bottom of the left hand panel, click Save.
5. Select the Config you would like to save the settings to, then click Save Settings to
Flash.
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.
PoE Web Smart Switch Series
54