Second Settings Screen (Level 2 Parameters) - Linde BOC Smootharc Advance MIG 425R Operating Manual

18 BOC Smootharc Advance III MIG 425R & 555R Operating manual

6.5 Second Settings screen (Level 2 parameters)

NOTE
Available in synergic mode only, need to select
'Synergic mode' to access 'Second Settings' screen.
Note: Only MIG/ SYN mode has Second SET Screen.
In the Home screen, select MIG/SYN mode and welding mode
(2T, 2TS, 4S & Spot) using left knob, turn Right knob to select Second SET,
and then press Right Knob to enter the Second SET Screen.
Different welding methods can set different parameters, as shown
in the figure below.
1. Rotate Left knob to switch
parameter options .
2. Rotate Right knob to set
the parameter value.
3. Short press the Back Button to
return to the Home Screen
Synergic mode Icons
Icon Description
Pre-gas time,
Range 0–5 sec
( Synergic 2T, 2TS,
4S modes only)
Start current
( Synergic 4S mode only)
Crater current
( Synergic 2TS & 4S
modes only)
Down-slope time
( Synergic 2TS & 4S
modes only)
Spot time,
Range 0.5 to 5 sec
Icon Description
Post-gas time,
Range 0–5 sec
( Synergic 2T, 2TS,
4S modes only)
Start ARC length,
Range -50 to +50
( Synergic 4S mode only)
Crater ARC length,
Range -50 to +50
( Synergic 2TS & 4S
modes only)
Please refer to Section 6.8 on following page for a trigger latch
explanation.
2T Screen
2TS Screen
4S Screen
Spot Screen