Adjusting Parameters - Linde BOC Smootharc TIG200 DC Operating Manual

5. Pre-gas Time
7. Up-slope Time
7.4

Adjusting parameters

Under the TIG mode, select the 2T (LIFT), 2T (HF), 4T (HF) or Spot (HF)
mode first by pressing the welding menu button for 3 seconds.
Select the parameters (Figures 5~14) to be set by pressing the welding
menu button, and then adjusting the parameter value using the
Adjustment Knob.
• The Start Current (Figure 6) and Up-slope time (Figure 7) are invalid
under 2T (HF) mode.
• The spot welding time (Figure 11) is only used in spot (HF) mode.
NOTE: If welding does not commence after 5 seconds the machine
will revert back to its default setting (See Figures 1–4).
BOC Smootharc TIG 200 DC Operating Manual
6. Start Current
8. Down-slope Time
35