Table of Contents
Advertisement
Choose 2T / 4T / Spot mode
Under the TIG welding mode, there are three
modes: 2T, 4T and Spot. Press the welding menu
button
for 3 seconds, and then release to
choose the mode, as shown in figures 5-7.
6.4 Adjusting parameters
Under the TIG mode, select the 2T, 4T or Spot mode
first by pressing the welding menu button
3 seconds.
Select the parameters to be set by pressing the
welding menu button
parameter value using the Adjustment Knob
(Figure 8).
• The Start Current (Figure 6) and Up-slope time
(Figure 7) are invalid under 2T (HF) mode.
• The spot welding time (Figure 11) is only used in
spot (HF) mode.
NOTE: When the digital TIG torch is connected,
the remote indicator
pressing the torch switch for 10s, and the
current could be adjusted by the knob on
the TIG torch.
The configured parameter value will be
automatically saved.
18
for
, and then adjusting the
will light up by
5. 2T mode
6. 4T mode
7. Spot mode
8. Adjusting parameters
Advertisement
Table of Contents
