Job Screen; Retrieving Jobs; 4T Trigger Latch Setting Explained - Linde BOC Smootharc Advance MIG 425R Operating Manual

6.6 JOB Screen

In the Main SET/Welding screen of MIG mode, long press (5
left knob to pop up SELECT JOB dialog box.
As shown in the figure below.
Selecting JOB
Save setting to JOB
6.7

Retrieving JOBs

1. In Main Set screen Rotate left
knob to JOB.
2. S hort press left knob to confirm.
3. Rotate to desired JOB.
4. S hort press left knob to confirm.
BOC Smootharc Advance III MIG 425R & 555R Operating manual
)
seconds
L
6.8 2T/4T Trigger Latch Setting explained
Trigger Latch
Ideal for short welds. A two-touch setting that requires the welder
2T
to press the torch trigger to start and release to stop.
Ideal for long welds. Press and release the torch trigger to start
4T
welding. Weld without holding the trigger on. Stop by pressing and
releasing the trigger again.
1. Long press (5 seconds) the
left knob to pop up the
SELECT JOB dialog box.
2. Rotate right knob to switch
JOB number.
3. Press right knob to pop up the
SAVE dialog box.
4. Rotate right knob to select
YES or NO.
5. S hort press left knob to confirm.
19