Step 10: End Panels - Arrow Storage Products Mountaineer Series Owner's Manual & Assembly Manual

Step 10: End Panels

You will need for this page:
SS
(QTY: 8)
1 Secure the End Panel to the Main Roof Beam
by placing a Small Screw in hole #1 (from the
diagram below). Carefully remove the Gable
Edge Trim once the Panel is in position.
2
Fasten Panel to Gable by placing Small Bolts
and Nuts through holes #2 - #7. Fasten the
holes in order.
Secure the Panel to the outer Roof Beam by
3
placing a Small Screw in hole #8. Repeat for
other three End Panels.
FASTEN TO NEXT PANEL
1
LEAVE THIS HOLE OPEN
2
LEAVE THIS HOLE OPEN
3
8578
4
8
5
6
7
LEAVE THESE HOLES OPEN
SB
(QTY: 24)
Nut
Washer
GABLE
2
8578 8579
Right End Left End
An Awl may be used to help
align holes that are only slightly
misaligned. Take care not to bend
or warp the metal, and always practice
proper tool safety.
8579
Bolt
31
2
If Roof Beam holes do not line up
with Roof Panel holes, shift the
building from left to right. If this does not
help, your building may not be level. Shim
the corners until holes line up.
1
2
3
8579
10'x10' (3,0 m x 3,1 m)
building shown.
Work one corner at a time. Be sure
to fi nish a corner before moving on to
the next one.
8
4
8578
5
6
7