Arrow Storage Products Mountaineer Series Owner's Manual & Assembly Manual page 20

Step 4:
You will need for this page:
LS SB
(QTY: 6+)
(QTY: 18+)
If you are erecting a 10'x10' (3,0 m x 3,1 m) building, skip this page
and move on to page 21.
57 1/2" (146,1 cm) behind the previous Truss,
6
erect a Truss Assembly and secure using a Large
Screw on each side. Once two Truss Assemblies
are in place, connect them with a Mid Side Wall Channel
and secure with Large Screws. Support Trusses until Mid
Side Wall Channels are in place.
Remove Bolts holding Truss peaks together (from
7
Step 1-6). Next, place two Middle Roof Beams
back-to-back and secure with two Small Bolts
and Nuts as shown. This is the Main Roof Beam.
Install the Main Roof Beam and secure with two
8
Small Bolts and Nuts at each end. Next, install
the outer Roof Beams in the same manner.
Repeat until all Trusses have been installed.
Main
Outer
Side of Beams with small holes must face up.
Continued for Extension Modules
2+
10632
Side Frame
Outer
2+
10634
10650
Side Wall
Roof Beam
Channel
All Truss Sections are assembled in the
5
same manner as the Truss Section just
erected. Install one additional Side Frame
per side for each additional Module. Overlap Side
Frames by 8 1/4" (21,0 cm). Refer to page 13 to
see how many Trusses should be included in your
building.
One Side Frame per side is added for
each additional Extension Module.
10650
20
4+
Assemblies from Step 1:
• All remaining Truss
Assemblies
10650
Main Roof Beam
10650
Main
Outer
10650
10650
Outer